Descripton

d00r-7r4d3-4dm1n

October 23, 2023

Sectional doors

Descripton

Sectional doors are an ideal solution for any production hall and premises, for storage areas, factories, car repair shops, etc.

Advantages:

I. Descripton
Sectional doors are an ideal solution for any production hall and premises, for storage areas, factories, car repair
shops, etc.
Advantages:
✓ Easy to use/operate;
✓ Save energy for heating and improve working conditions;
✓ Save space outside and inside the room;
✓ Require minimal maintenance;
✓ Made according to individual dimensions of the light opening and a minimum is required preparation for their
placement;
✓ Reliable and secure.

II. CERTIFICATES :

The materials used for the production of LOGEL sectional doors are imported from Germany, the Netherlands and
Belgium and meet all European standards for quality and safety concerning the product.

III. Track Systems

Low lift with rear springs – LL

Opening system, where the height of the beam is up to
200mm. This reduces the space required for over-the-
door installation.

Standard lift- SL

An opening system in which the door moves on rails turning
directly over the clear opening. Depending on the height of
the opening, the beam should be between 410mm and
510mm.

High lift – HL

An opening system where the door opens vertically
upwards, then swings under the roof.

Vertical contour – VL

An opening system where the door opens vertically
(guillotine type)

Low lift with a slope – FRLL

An opening system where the door swings directly over the
light opening and follows the slope of the roof. The slope can
be from 5° to 40°.

High lift with a slope – FRHL.

An opening system where the door opens vertically
along the wall, then follows the slope of the roof. The
slope of the roof can be from 5° to 40°.

IV. Panels

The doors are made of a “sandwich” panel with a thickness of 40 mm and a height of 488 mm, 610 mm and 732 mm. Each panel consists of two outer layers of steel, deep-galvanized, profiled sheet metal with a thickness of 0.5 mm, ensuring reliable corrosion resistance of the panels. The core of the panel consists of high-density polyurethane foam with an interrupted thermal bridge. The insulation between the panels is carried out by a special seal. The factory powder coating of the panels provides an evenly applied color
resistant to all weather conditions. The outer surface can be made of “Stucco” or “Microribs”